Home-Knowledge-

Content

Technical skills of manual or machine lining

Jul 08, 2022

1. The thickness and texture of the adhesive lining shall be consistent with the thickness and texture of the fabric. Because the high-end garment technology needs to be processed by the process of drawing back, the spinning lining with good elasticity and high fastness should be used.

2. The color of the adhesive lining shall be consistent with the color of the fabric. If there is no such possibility, light colored fabrics must not be matched with dark linings, and opaque dark colored fabrics can be matched with light colored linings.

3. For the part of the fabric that has not been pre shrunk at high temperature and needs to be bonded, a margin shall be left around during cutting to prevent the fabric from shrinking after high temperature bonding.

4. When cutting the adhesive lining, the same yarn direction as the garment piece is usually used. However, as high-end clothing needs to be pushed, returned, pulled and pressed, it is better to use 45° oblique yarn for cutting the adhesive lining used in high-end technology. Because the 45 ° oblique yarn has good elasticity and a certain degree of stretch, it is easy to pull back.

5. When cutting the adhesive lining, in order to prevent the adhesive lining from sticking to the iron or adhesive machine, the circumference of the cut lining shall be 0.2 ~ 0.3cm smaller than the circumference of the fabric.

6. The adhesive lining shall be softened by hand before bonding. In case of false or manual bonding, the garment piece shall be paved on the cutting board first, and then the adhesive lining shall be placed on the garment piece, so that the garment piece is below and the adhesive lining is above.

7. In case of manual operation, the temperature of the iron should be controlled between 130 ℃ and 160 ℃, so as not to cause degumming of the adhesive lining and blistering of the clothes. If the temperature is too low, it will not stick firmly.

8. During machine bonding, the temperature of the fabric or bonding lining shall be determined before bonding to avoid scorching, shrinking or degumming of the fabric. Machine bonding cannot be repeated for the same part to avoid degumming.

9. In case of manual or pseudo bonding, for parts with large bonding area (such as front garment pieces), it is better to conduct spot welding first. The bonding shall be started from the middle, and then gradually spread to the surrounding.

10. During manual or pseudo bonding, the worktable shall be flat without unevenness. When manually bonding, it is best to prepare a cold iron first, and timely cool and set the bonded part. The bonded garment pieces must be laid flat, and the next process can be carried out after cooling to prevent deformation of the garment pieces.


SEND INQUIRY

SEND INQUIRY